How To
Drain your tub
Drain your tub easily with the provided water hose drainage connector, found in the accessories box of your order. The videos below will show two ways of draining your tub, and explain a few alternative methods in addition. METHOD ONE: (Preferred). P
Remove the lid
The Modtub 2.0 features a redesigned lid that’s simpler than ever to remove. Watch the video below for a quick step-by-step guide on how to easily take off the li.
Water Shutoff Points
If you ever need to stop water from flowing through the unit, or remove a component without draining the tub, you will need to know where the shutoff points are, and make sure they are closed. This video will show all three of the water shutoff point
Properly Seat and Tighten Chiller Fittings
Check out this video showing how to properly seat and tighten your chiller fittings, for a leak-free experience. TIP: Attach the HOSE 4 to the chiller FIRST. Once hose 4 is connected to chiller, attach the other side of the hose to the TUB.
Remove and Open the Pump
Follow these steps and the video below to remove the pump from your unit, and rotate the cap off. 1. Power down the unit. 2. Close both the valve on the filter and the drain plug. 3. Unscrew the hoses that are attached to the pump. 4. Rotate the cap
Set Up JED 303 Ozone Generator
Here’s a quick video that walks you through how to install the JED 303 ozone generator on your Modtub 2.0.
Tub Only - Removing Unions to access 3/4" female NPT
In this quick tutorial, we’ll show you how to remove the unions that come standard on the Modtub 2.0. This simple step gives you direct access to the built-in 3/4" female NPT threads, which are needed if you’re setting up the tub only (without the fu